Fall Protection

It may seem that a job can be performed more efficiently without spending the time to protect against falls. However, falls remain one of the top causes of fatalities in construction. Workers have fallen off edges of every description, especially floors and roofs, and through openings in floors, roofs, and walls. Fall protection is required whenever a worker faces serious risk of injury, including:

  • on structures where a worker could fall more than 7 feet
  • on thrustouts, trusses, beams, purlins, and plates at heights over 15 feet
  • on a sloped roof
  • To prevent accidental falls at worksites, guardrails and toeboards or other effective barriers to falls should be used. However, there will be areas where guardrails or other barriers are not feasible. In these cases, workers must use approved personal fall protection systems or positioning devices.
  • Two basic types of person fall protection systems that require tie off are fall arrest and travel restraint. Fall arrest systems stop a fall within a few feet of the worker’s original position. A full body harness is required with a fall arrest system. The system typically consists of a full body harness, a lanyard, a rope grab, a lifeline, and a lifeline anchor. A fall arrest system must be worn when working on a rolling scaffold that is being moved or when a worker is getting on, working from or getting off suspended access equipment.

    A travel restraint system prevents falls by restraining a worker from getting too close to an unprotected edge. This system usually consists of a safety belt or full body harness, a lanyard, a rope grab, a lifeline, and a lifeline anchor.

    When conventional fall protection or personal fall protection are not practical, safety nets must be used instead. Before using safety nets, check to see that the nets are hung with enough clearance to prevent a falling person from hitting the surface or structure below.

    Safety nets should be placed within 10 vertical feet and never more than 30 feet below the working surface. Nets must extend at least eight feet beyond the building or structure. If the vertical distance from the working level to the net is greater than 5 feet, then the net must extend 10 feet beyond the building. A net from 10 feet to 30 feet below the working surface must extend 13 feet.

    If you use any type of fall protection equipment, including personal fall protection or safety nets, be sure to check that you are using the right equipment for the job, labeled as meeting the requirements of the American National Standards Institute (ANSI), and that the equipment is in good condition.

    Whenever feasible, employers should always set up temporary floors, guardrails, toeboards, or other physical barriers to falls, instead of having workers rely on typing off and nets for fall protection. When not feasible, personal fall protection or safety nets must be used. No work should proceed unless the necessary fall protection is in place. The use of fall protection can prevent serious injury and save your life.

     

    © 2010 OilFieldStuff.com - All Rights Reserved. | Website Design by SemmesWebDesign

    OilfieldStuff.com. (hereinafter OFS) make no representations about the suitability of the information contained on this web site for any purpose. This web site and all of the information it contains is provided "as is" without warranty of any kind whether express or implied. In no event shall OFS be liable to any person or business entity for any special, direct, indirect, punitive, incidental or consequential damages arising out of or in connection with the use of this web site or any other web site to which this site is linked, including, without limitation, any lost profits, business interruption, or loss of programs or information. OFS shall not be responsible for any errors or omissions contained in this web site and reserves the right to make changes without notice. User therefore acknowledges and accepts that the information published on this web site may include technical inaccuracies or typographical errors. The hypertext links on this web site will allow you to leave this web site. The links are provided as a service to users and are not sponsored by or affiliated with this web site or under the control of OFS. The links are to be accessed at the user's own risk, and OFS and the authors of this web site make no representation or warranties about the content of these links. OFS is not responsible for the content of any linked site or any link contained in a linked site. OFS is providing these links to you only as a convenience, and the inclusion of any link does not imply endorsement by OFS of the site.